About two years ago, maybe a bit more, I was asked how I make and use my handheld distaves, so I wrote this up with some photos showing how I use my oldest spindle, which I still use today, even though at one point I managed to snap it in half (😳), but I glued it back together and it's still working exactly as well as ever. 🤷 Anyway, here's the distaff I use most of the time I'm spinning:

It’s 1/4 if a dowel I bought from home Depot for like 85 cents, so I guess this part cost me like 22 cents. It’s about a foot long, and the ends are pointed just because the help yourself saw at Home Depot was kind of dull, so the edges weren’t very neat and I didn’t like how they looked. And since this dowel is around the same size as a pencil sharpener, it was easy to shape them this way. It started out straighter, but its kind of curved over time from being held and its more comfortable now than almost 3 years ago when i first started using it. I now have a couple other distaves I've made, but this the one I turn to most often, because it's already shaped well to my hand over prolonged use.

To dress it I just start like winding a cop on a spindle and basically keep loading it on like a spindle until it’s full. I know some people like thicker tops/rovings, but I like to strip it down to about finger-width because it flows better. I’ve drafted across the top from my distaff before, but its kind of annoying in my opinion. Then again, I'm usually spinning finer yarns; your ideal fiber thickness does depend a bit on your ideal finished single. If your fiber supply is thinner than the single you'd like to spin, you're going to have a bad time. You also don't want to pre-draft to the ideal finished diameter because once you add spin, a good amount of the air is pressed out and of course the diameter decreases in turn. So it's a dance of getting close to ideal width, but wide enough that you can still edit the single before adding spin.

This is how I hold it/ draft, though if there’s a slub or something the first 3 fingers help and it’s only the bottom two holding the stick. My hand moves back and forth from this position to the one with the first three fingers helping pretty freely. Sometimes I rotate the spindle in my fingers bit by bit to keep the roving flowing freely, and at other times, I'll unloop a strand of fiber and work that bit by bit; it mostly depends on how quickly I'm able to draft this particular fiber.
Hope that helps somebody!
No comments:
Post a Comment